Posts
2851
Following
167
Followers
86
AS4242423219 on DN42
Also @noisytoot@mice.tel in case chinchillas eat the cables
I disabled flashconsole and it boots to linux! apparently flashconsole is buggy and doesn't work past early boot
1
0
0
repeated

kinda mean, don't you think?

0
6
3
mreoww
0
0
0
repeated

@catsalad Our previous one was heavily into telecommunications theory…

0
4
2
meow
1
0
0
@hexaheximal yes, and it's better than ch341a because it's fully 3.3V
1
0
1
good morning/afternoon
0
0
0
finally going to bed
0
0
0

my pico 2 can’t reliably write to the flash chip, sometimes it fails with an error like

Verifying flash... FAILED at 0x00823901! Expected=0xfa, Found=0xff, failed byte count from 0x00000000-0x00ffffff: 0x1

maybe the drive strength is insufficient (even though I have it set to the maximum the pico 2 can provide (12mA))

it’s not really a big problem though since I can just retry and it usually succeeds

1
0
0
I nearly did the very stupid mistake of accidentally flashing my laptop (the one I'm actually using, not the P51) internally with the P51's firmware instead of using my USB flasher (a pi pico 2), but was luckily prevented from doing so by /dev/mem protection
2
0
0
inteltool didn't support dumping GPIOs on the Intel CM238 chipset so I just modified it to treat it the same was as CM236 (and other non-LP sunrise point chipsets), hopefully that's correct (I think it should be, but I have no idea and can't actually find the CM238 datasheet (the 100-series and C230 series datasheet mentions it but doesn't list it in the SKU definition section at the beginning)

I also just commented out the dGPU initialization sequence since the one for the ThinkPad T480 uses GPIO pins that don't exist on the P51 (I have no idea how to find the correct one)

Initially I completely forget to configure GPIOs and didn't notice that my dumps were missing GPIOs so I had to return to stock firmware to re-run inteltool after modifying it
1
0
0
Edited 5 days ago

I tried booting my ThinkPad P51 coreboot port (for the first time) today, and it reached ramstage, but seems to be hanging somewhere in post_mp_init for some reason. The last lines in the flashconsole log are:

bsp_do_flight_plan done after 15 msecs.
CPU: frequency set to 4000 MHz
Enabling SMIs.
Locking SMM.
VMX status: enabled
VMX status: enabled
IA32_FEATURE_CONTROL status: locked
VMX status: enabled
1
0
0
@babble_endanger Another nice thing about TUIs is that they are almost universally usable entirely with a keyboard (without a mouse), but GUIs not being usable without a mouse is more of a design flaw with those specific GUIs rather than with GUIs in general.
0
0
1
@babble_endanger I wouldn't say that TUIs are simpler, they just move much of the complexity (and thus attack surface) to the terminal emulator, and they're also awful for accessibility. CLIs are simpler, however.

That said, I do prefer TUIs for many things primarily because using any sort of GUI thing remotely is a pain and using a TUI over SSH is so much easier than messing with remote desktop software.
1
0
1
getting out of bed after sunset again
0
0
0
Show older